付武;王永强;蒋金玉;郭福德;
FU Wu1,WANG Yong-qiang2,JIANG Jin-yu3,GUO Fu-de3(1.Troops 65066,Dalian 116100,Liaoning,China;2.Troops 65307,Jilin 132002,Jilin,China;3.Chun'an Blasting Engineering Co.of Jilin Province,Changchun 130000,China)

• 1:解放军65066部队
• 2:解放军65307部队
• 3:长春市春安爆破公司
• 4:长春市春安爆破公司 辽宁大连116100

摘要(Abstract)：

介绍了用定向控制爆破方法拆除吉化电石厂120m钢筋混凝土烟囱的经验。针对该烟囱下部有1个门和3个窗户的特殊结构,选择倒梯形爆破切口,以增强预留支撑面的强度。为防止烟囱落地产生震动和前冲,在倒塌的前方设置了减震带和阻冲挡土墙。文中同时还阐述了参数的选择与计算,以及爆破效果。文中总结的四点经验值得借鉴。
The paper introduced the experience from the demolition of a 120m reinforced concrete chimney by directional controlled blasting.The chimney to be demolished featured the special structure by its one gate and three windows affixed at its lower section.Regarding this structure,a reverse trapezoid cut was determined for the demolition so as to strength the supporting intension of the preserved interface.For avoiding the dash and minimize vibration caused by the collapse,some cushion ribbon and a resistant hillock were mounted on the ground in the direction of the collapse.The paper also presented in detail the information on selection of blasting parameters,the safety protection measures,the blasting effect as well as the mechanics calculation etc.The four items of experience summarized in this paper was of consultable value.

关键词(KeyWords)： 钢筋混凝土烟囱;爆破拆除;爆破切口;安全防护
Reinforced concrete chimney;Blasting demolition;Blasting cut;Safety protection

Abstract:

Keywords:

基金项目(Foundation):

作者(Authors): 付武;王永强;蒋金玉;郭福德;
FU Wu1,WANG Yong-qiang2,JIANG Jin-yu3,GUO Fu-de3(1.Troops 65066,Dalian 116100,Liaoning,China;2.Troops 65307,Jilin 132002,Jilin,China;3.Chun'an Blasting Engineering Co.of Jilin Province,Changchun 130000,China)

参考文献(References)：

• [1]冯叔瑜,吕毅,杨杰昌,顾毅成.城市控制爆破(第二版)[M].北京:中国铁道出版社,2000.
• [2]刘强,高振儒.烟囱定向爆破拆除的预处理方法[J].爆破,2001(3):47-49.
• [3]龙源,纪永适.80m高钢筋混凝土烟囱的爆破拆除[J].爆破,1995(4):12-16.
• [4]阎家良.结构物爆破[R].中国人民解放军工程兵工程学院,1985.
• [5]林学圣,阎家良.控制爆破[R].中国人民解放军工程兵司令部,1982.
• [6]杨年华.百米以上钢筋混凝土烟囱定向爆破拆除技术[J].工程爆破,2004,10(4):26-30.
• [7]郑炳旭,傅建秋,王永庆,等.150m高钢筋混凝土烟囱双向拆叠爆破拆除[J].工程爆破,2004,10(3):34-36.