王银涛,刘坚,刘敬智,李银忠
WAN Yin-tao,LIU Jian,LIU Jing-zhi,LI Yin-zhong

• 1:北方爆破科技有限公司
• 2:万宝矿产有限公司

摘要(Abstract)：

为简化缅甸莱比塘铜矿寺庙附近控制爆破区域施工流程，减少控制爆破区域面积，扩大爆破开采规模，提出在寺庙与爆源之间安排减振孔隔振的方法。在含水土层减振孔施工过程中，提出管内注水、管外填砂、最后抽水成空管的施工方法。施工后对减振孔两侧以及寺庙附近进行爆破振动监测并分析研究。结果表明减振孔对爆破振动峰值减弱作用明显；对减振孔后侧点的爆破振动信号进行非线性回归分析，与无减振孔的爆破振动衰减公式对比分析，随着爆源与寺庙的距离增加，减振孔对爆破振动信号的减振作用逐渐减小；根据重新拟合的公式对控制爆破区域重新划分，提高了爆破开采效率。
In order to simplify the construction process of controlled blasting area near the temple of Laibitang Copper Mine in Myanmar, reduce the area of controlled blasting and expand the blasting mining scale, a method of arranging vibration isolation holes between the temple and the blasting source is proposed. In the construction process of damping holes in water and soil bearing layer, the construction method of injecting water in the pipe, filling sand outside the hole and finally pumping water out to leave an empty pipe is put forward. After construction, the blasting vibration on both sides of the damping holes and near the temple is monitored and analyzed. The results show that the damping hole has an obvious damping effect on reducing the peak value of blasting vibration. The blasting vibration signal at the rear side of the damping hole is analyzed by nonlinear regression, which is compared with the blasting vibration attenuation formula without damping holes. With the increase of the distance between the blasting area and the temple, the damping effect of the holes on the blasting vibration signal decreases gradually. The controlled blasting area is re-divided according to the re-fitting formula, which improves the blasting mining efficiency.

关键词(KeyWords)： 控制爆破;减振孔;爆破振动;回归分析
control blasting;damping hole;blasting vibration;regression analysis

Abstract:

Keywords:

基金项目(Foundation):

作者(Author): 王银涛,刘坚,刘敬智,李银忠
WAN Yin-tao,LIU Jian,LIU Jing-zhi,LI Yin-zhong

DOI: 10.19931/j.EB.20200037

参考文献(References)：

• [1] 潘涛，康强，赵明生，等.减振沟相关参数对减振效果影响的数值模拟[J].金属矿山，2013,42(5):45-48.PAN T,KANG Q,ZHAO M S,et al.Numerical simulation of the influence of the parameters of the damping ditch on the damping effect [J].Metal Mine,2013,42(5):45-48.
• [2] 郑文富.减振孔参数对降振效率影响研究[D].湘潭：湖南科技大学，2016.ZHENG W F.Study of damping hole parameters infiuence on blasting vibration reduction[D].Xiangtan:Hunan University of Science and Technongy,2016.
• [3] 彭宝文.减振沟对爆破振动效应影响的研究[C] //中国铁道学会工程分会.爆破工程技术交流论文集，2018:222-230.PENG B W.Study of the influence of damping ditch on blasting vibration effect[C] // Engineering branch of China Railway Society.Collection of papers on blasting engineering technology exchange,2018:222-230.
• [4] 孙崔源，薛里，孟海利，等.几种典型爆破振动控制技术的试验研究[J].北京理工大学学报，2018,38(4):359-363,370.SUN C Y,XUE L,MENG H L,et al.Experimental study on several typical blasting vibration control technologies[J].Beijing University of Technology Journal,2018,38(4):359-363,370.
• [5] 何兴贵，左宇军，赵明生，等.减振孔对爆破振动的影响规律研究[J].矿业研究与开发，2016,39(9):93-96HE X G,ZOU Y J,ZHAO M S,et al.Study on the influence law of damping hole on blasting vibration[J].Mining Research and Development,2016,39(9):93-96.
• [6] 雷兴海，吴桂义，雷振，等.露天控制爆破振动对邻近建筑物影响的分析[J].采矿技术，2021,21( 2) :124-128.LEI X H,WU G Y,LEI Z,et al.Analysis of the influence of open-pit controlled blasting vibration on adjacent build- ings[J].Mining Technology,2021,21 ( 2) :124-128.
• [7] 国家安全生产监督管理总局.爆破安全规程：GB 6722-2014[S].北京：中国标准出版社，2015.State Administration of Work Safety.Safety regulations for blasting:GB 6722-2014[S].Beijing:China Standards Press,2015.