何理;钟冬望;司剑峰;
HE Li;ZHONG Dong-wang;SI Jian-feng;College of Science,Wuhan University of Science and Technology;CRPCE-WUST Blasting Technology Research Center;

• 1:武汉科技大学理学院
• 2:中铁港航-武科大爆破技术研究中心

摘要(Abstract)：

临近边坡毫秒延时爆破时需综合考虑岩体爆破效果及保留岩体稳定两方面因素,结合数码电子雷管开展毫秒延时爆破相似模型试验,采用动态应变测试仪及高速相机分别对边坡应力场和岩体裂缝扩展情况进行监测。结果表明:减振沟作用下,边坡表面径向应力峰值由2.26MPa降低为0.84MPa,切向应力峰值由1.16MPa降低为0.95MPa,径向与切向应变平均减振率分别为49.4%和35.2%;孔间延时时间为15ms或25ms时,可降低延时时间对应变峰值影响;孔间延时时间为11ms时,裂缝宽度平均值为11.79mm,可形成新自由面,孔间延时时间大于15ms,后孔爆破时,前序药包残余应力场几近消失。试验条件下,最优孔间延时时间为15ms。
The rock blasting effect and stability of reserved rock mass should be considered at the same time in millisecond delay blasting near slope.Combined with digital electronic detonators,the similar model test of millisecond delay blasting was designed and carried out.Dynamic strain tester and high-speed camera were used to monitor stress field and crack propagation of slope rock mass respectively.The results showed that,under the action of damping ditch and on the slope surface,radial peak stress decreased from 2.26 MPa to 0.84 MPa,tangential peak stress decreased from 1.16 MPa to 0.95 MPa,and the average damping rates of radial and tangential strain were 49.4% and 35.2%respectively.The influence of delay time on the peak strain was reduced with 15 ms or 25 ms.The average width of crack was 11.79 mm that could form new free surface with delay time of 11 ms.The residual stress field of previous explosive charge almost disappeared when subsequent explosive charge detonated with delay time longer than 15 ms.Under experimental conditions,the optimal delay time between blasting holes was15 ms.

关键词(KeyWords)： 边坡;毫秒延时爆破;应力场;爆破效果;延时时间;数码电子雷管
Slope;Millisecond delay blasting;Stress field;Blasting effect;Delay time;Digital electronic detonator

Abstract:

Keywords:

基金项目(Foundation): 国家自然科学基金项目(51174147、51574184);; 武汉科技大学研究生创新基金项目(JCX0017)

作者(Authors): 何理;钟冬望;司剑峰;
HE Li;ZHONG Dong-wang;SI Jian-feng;College of Science,Wuhan University of Science and Technology;CRPCE-WUST Blasting Technology Research Center;

参考文献(References)：

• [1]王军跃.爆破振动信号叠加法及其在露天矿的应用[D].武汉:武汉理工大学,2007.WANG Jun-yue.Superposition method of blasting vibration and its application in open-pit mine[D].Wuhan:Wuhan University of Technology,2007.
• [2]付天光,张家权,葛勇,等.逐孔起爆微差爆破技术的研究和实践[J].工程爆破,2006,12(2):28-31.FU Tian-guang,ZHANG Jia-quan,GE Yong,et al.Study and practice of technology of millisecond blasting ignited in borehole sequence[J].Engineering Blasting,2006,12(2):28-31.
• [3]占时春,李山存.孔内孔间微差爆破试验研究[J].工程爆破,2006,12(2):45-48.ZHAN Shi-chun,LI Shan-cun.Experimental study on millisecond blasting both in-and-among holes[J].Engineering Blasting,2006,12(2):45-48.
• [4]何理.爆破荷载作用下岩质边坡动力稳定性研究[D].武汉:武汉科技大学,2012.HE Li.The research on rock slope dynamic stability under blasting loading[D].Wuhan:Wuhan University of Science and Technology,2012.
• [5]何理,钟冬望,刘建程,等.微差爆破试验及爆破振动能量的小波包分析[J].金属矿山,2014(6):10-15.HE Li,ZHONG Dong-wang,LIU Jian-cheng,et al.Model test and wavelet packet analysis of energy for millisecond blasting vibration signals[J].Metal Mine,2014(6):10-15.
• [6]钟冬望,吴亮,陈浩.爆炸荷载下岩质边坡动力特性试验及数值分析研究[J].岩石力学与工程学报,2010,29(S1):2964-2971.ZHONG Dong-wang,WU Liang,CHEN Hao.Model test and numerical simulation study of dynamic characteristics of rock slope under blast loading[J].Chinese Journal of Rock Mechanics and Engineering,2010,29(S1):2964-2971.
• [7]王建国,黄博,吴海燕,等.爆破荷载下边坡动态响应的FLAC3D模拟研究[J].工程爆破,2014,20(2):6-9.WANG Jian-guo,HUANG Bo,WU Hai-yan,et al.FLAC3Dsimulation for dynamic response of the slope under explosion loading[J].Engineering Blasting,2014,20(2):6-9.
• [8]陈明,卢文波,周创兵,等.基于等效加速度的岩质边坡爆破动力稳定性[J].爆炸与冲击,2011,31(5):475-480.CHEN Ming,LU Wen-bo,ZHOU Chuang-bing,et al.Rock slope stability under blasting vibration based on equivalent acceleration[J].Explosion and Shock Waves,2011,31(5):475-480.
• [9]何理,钟冬望,刘建程,等.基于矢量和法安全系数的边坡稳定性分析[J].武汉科技大学学报.2013,36(6):455-460.HE Li,ZHONG Dong-wang,LIU Jian-cheng,et al.Slope Stability Analysis based on vector sum safety coefficient[J].Journal of Wuhan University of Science and Technology,2013,36(6):455-460.
• [10]钟冬望,吴亮,韩芳,等.爆炸载荷下岩质边坡动力响应及控制[M].北京:科学出版社,2011:120-122.ZHONG Dong-wang,WU Liang,HAN Fang,et al.Dynamic response and control of rock slope under explosive loading[M].Beijing:Science Press,2011:120-122.
• [11]苏华友,陆文.微差爆破间隔时间合理性分析[J].四川冶金,2000(3):15-17.SU Hua-you,LU Wen.Rationality analysis of interval time in millisecond blasting[J].Sichuan Metallurgy,2000(3):15-17.
• [12]罗开军.孔内孔间微差爆破间隔时间的合理选择[J].金属矿山,2006(4):4-6.LUO Kai-jun.Rational selection of delay time in in-hole and between-holes microsecond blasting[J].Metal Mine,2006(4):4-6.
• [13]高富强,侯爱军,杨小林,等.基于量纲理论的爆破振动持续时间分析[J].金属矿山,2010(9):143-145.GAO Fu-qiang,HOU Ai-jun,YANG Xiao-lin,et al.Analysis of blasting vibration duration based on dimension theory[J].Metal Mine,2010(9):143-145.